Description
Our Copper End Feed Fitting Reducer is perfect for connecting two pipes of different sizes in your plumbing system. This high-quality fitting is designed to ensure a secure and leak-free connection, making it ideal for both DIY projects and professional installations.
Technical Attributes:
– Material: Copper
– Size: 67mm x 42mm
– Pressure: Suitable for use with both hot and cold water systems
– End Feed: Provides a quick and reliable way to connect pipes without the need for soldering
Installation Instructions:
1. Measure and mark the pipes to determine where the reducer will be installed.
2. Using a pipe cutter, cut the pipes at the marked locations.
3. Clean the cut ends of the pipes using a wire brush to ensure a secure fit.
4. Slide the reducer onto one of the pipes, ensuring it goes all the way in.
5. Heat the joint with a blowtorch until the solder melts and flows evenly around the joint. Be sure to apply the heat evenly to avoid any leaks.
6. Check for any leaks by running water through the system.
Always refer to manufacturers installation instructions
– Make sure to deburr the cut ends of the pipes to prevent any interference with the fitting.
– Apply a thin layer of soldering flux to the inside of the reducer before connecting the pipes for a secure fit.
– Use a pipe wrench to tighten the fitting and prevent any loosening over time.
Upgrade your plumbing system with our Copper End Feed Fitting Reducer and ensure a reliable and durable connection between pipes of different sizes.
Reviews
There are no reviews yet.