Pegler Xpress Copper 28mmx22mm S1R Reduced Coupling

Description

The Pegler Xpress Copper 28mmx22mm S1R Reduced Coupling is a high-quality plumbing fitting designed for joining two copper pipes of different diameters. This coupling is perfect for connecting 28mm and 22mm copper pipes securely and efficiently.

Technical attributes:
– Material: Copper
– Pressure rating: 16 bar
– Size: 28mm x 22mm
– Type: S1R Reduced Coupling

Installation instructions:
1. Cut the 28mm and 22mm copper pipes to the desired length, ensuring that the ends are clean and free from any debris.
2. Slide the coupling onto one of the pipes, ensuring that it sits securely in place.
3. Apply a small amount of flux to the end of each pipe to ensure a tight seal.
4. Insert the other pipe into the other end of the coupling and push it in until it is fully seated.
5. Use a pipe wrench to tighten the coupling securely in place.
6. Check for any leaks by turning on the water supply and inspecting the joint.

Always refer to manufacturers installation instructions
– Make sure to measure and cut the pipes carefully to ensure a proper fit.
– Clean the pipe ends thoroughly before applying flux to ensure a watertight seal.
– Use a pipe wrench to tighten the coupling securely, but be careful not to overtighten to avoid damaging the pipes.
– Check for leaks after installation to ensure the joint is secure and watertight.