Solvent Weld 40mm 135 Degree Spigot Bend (Colour Black)

Description

The Solvent Weld 40mm 135 Degree Spigot Bend in black is a high-quality plumbing fitting designed for joining two sections of 40mm solvent weld pipes at a 135-Degree angle. This spigot bend is commonly used in drainage and wastewater systems for residential and commercial applications.

Technical attributes:
– Material: PVC (Polyvinyl chloride)
– Pressure rating: Suitable for low pressure applications
– Size: Fits 40mm solvent weld pipes
– Color: Black

Always refer to manufacturers installation instructions
1. Ensure that the pipes are clean and dry before applying solvent cement to both the pipe and the spigot bend.
2. Insert the spigot end of the bend into the pipe firmly and hold in place for a few seconds to allow the cement to set.
3. Check for proper alignment before the cement fully sets to avoid any leaks in the future.
4. Allow the solvent cement to cure according to the manufacturer’s instructions before testing the joint for water-tightness.

By following these PlumbingWholesale.co.uk Installation Advice, you can effectively and securely connect two sections of 40mm pipes using the Solvent Weld 40mm 135 Degree Spigot Bend in black.